Remove the thumbscrew from the new cartridge and retain thumbscrew to use when storing the used cartridge that has material inside. Press “Next” on the touchscreen, a message “Heating Print Jet Please Wait…” will appear on the control panel.Ģ. Print Jet 1 represents bay 1, Print Jet 2 represents bay 2 and Print Jet 3 represents bay 3. Press REPLACE on the touchscreen and select the bay that the cartridge will be installed. Exit the "LEVEL" function by pressing the control button. Once you have finished leveling the entire print plate, make sure the locking nuts are tightened and secure and place the print pad back on the print plate. It may take several Print Jet movements and bolt adjustments to ensure that the Print Plate is level.
After adjusting the print plate, place the print pad back on and continue using the arrows, clockwise and counterclockwise buttons to check the gap length between the jets and pad.
Cubify cube x duo driver#
To adjust the height of the print plate, use the 3mm hex driver from the tool kit to adjust the height of the three bolts to ensure the plate is leveled evenly.ĥ. There are locking nuts under each of these bed bolts that must be loosened with the 8mm spanner wrench before the bolts can be adjusted.Ĥ. Near the front and back corners of the print plate are three bolts that can be adjusted to change the height of the plate. Remove the print pad off of the print plate. Tap on the clockwise and counterclockwise position and observe the print jet’s print jet tip moves around the print pad from the side of pad, checking for inconsistencies in the gap distance between the jet and pad.ģ. Using the arrows, adjust the distance between the print jet and print pad to approximately 10mm. Scroll to the "LEVEL" function screen located in the CubeX control panel.Ģ. * Do not use the offset menu unless you have been advised to do so by Cubify support, changing this may affect the quality of multi-material prints.ġ. Offset Set the relative distance between each print tip Z-Gap Set the distance between the print pad and print tips during the first layer of printing. Level Level your print pad in relation to the print tips. Home Sends the print jet carriage to its home position located in the back left corner of the printer. Move Manually moves your print jet carriage in the X, Y and Z directions. PJ-Con Allows you to manually jet your print jets, giving you control of temperature and RPM. PJ-Map Allows you to re-map your print jets. Info Provides Material Cartridge status and printing status during the printing process. cubex files that are saved on your memory stick and select a. To return to the touchscreen, press the control button. Touchscreen Tap on the touchscreen to the main menus using the arrows on the bottom corners of the touchscreen. The rest of this page goes into specific detail of how the CubeX printer works from experience using it and information from the user guide. The print jet is accommodated by the print plate, which lowers incrementally after each layer is deposited so a new layer can be drawn on top of the last, building the The filament is then jetted through the print tip in a thin string of molten plastic. The CubeX creates the model by pulling filament from the cartridge through the print jets via the delivery tubes. cubex file onto your USB drive and plug the drive into your CubeX. cubex file, which the CubeX uses to build the part.
Cubify cube x duo software#
Before the part can be printed, it must be opened into the CubeX Software (CubeX Software accepts both.
Cubify cube x duo download#
General Overview: To begin the process of creating a printed part from a 3D model, design a part in a CAD package or download one from. This process continues through the final layer, until your creation is complete. The print pad lowers after each layer so that each one builds upon the last. The CubeX 3D Printer creates three-dimensional parts with print tips that heat material to extrude a thin string of plastic which adheres to print pad layers.